Default Settings
netBooter B and DU Series PDUs are preconfigured with the following default settings:
Default Networking Settings
- Static IP Address: 192.168.1.100
- Subnet Mask: 255.255.0.0
- Gateway: 192.168.1.1
Default Serial Connection Settings
- Baud Rate: 9600
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
Default Login Credentials
- Username: admin
- Password: admin
Booting in DHCP Mode
If your network requires DHCP, you can enable it through the serial console, by connecting the web UI first over static IP, or by pressing and holding the pin in the front "RST" hole while powering on the device. The pin must be held before and during power-up.
Once DHCP is enabled, the default name of the PDU is "REMOTEPDU". Alternatively, you can locate the PDU using the MAC address printed on the product label on top of the unit.
Resetting to Factory Defaults
- Press and hold the RST button for 3-5 seconds; the PDU needs to already be powered on when pressing the RST button.
- Note that holding the RST button for too long (e.g. 10+ seconds) will simply restart the PDU instead of performing a factory reset
- This resets all settings, including the admin credentials.
- Power to outlets may briefly turn off and on!
