Default Settings
netBooter DX Series PDUs are preconfigured with the following default settings:
Default Networking Settings
- IP Addressing Mode: DHCP
Default Serial Connection Settings
- Baud Rate: 115200
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
Default Settings
netBooter DX Series PDUs are preconfigured with the following default settings.
Default Networking Settings
- IP Addressing Mode: DHCP
Default Serial Connection Settings
- Baud Rate: 115200
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
Default Login Credentials
- Username: admin
- Password: admin
Booting in Static Mode
If you require static IP addressing mode, you can enable it in any of the following ways:
- Through the serial console
- Through the web UI, by first connecting over static IP
- By pressing and holding the pin in the front "RST" hole for 10 seconds while powering on the device. The pin must be held before and during power-up.
Resetting to Factory Defaults
The PDU must already be powered on before pressing the RST button.
- Press and hold the RST button for 9–12 seconds, until the AC Current Amps reading resets. Release the button as soon as the AC current amps reading turns off.
- This resets all settings, including the admin credentials.
- Power to the outlets will not be affected.
Note: Holding the RST button too long (20+ seconds) will cause the PDU to enter static IP addressing mode. Release the button as soon as you see the AC current amps turn off.
Default Login Credentials
- Username: admin
- Password: admin
Booting in Static Mode
If you require static IP adressing mode, you can enable it through the serial console, by connecting the web UI first overstatic IP, or by pressing and holding the pin in front "RST" hole while powering on the device for 10 seconds. The pin must be held before and during power-up.
Resetting to Factory Defaults
- Press and hold the RST button for 9-12 seconds unti the AC Current Amps reading resets; the PDU needs to already be powered on when pressing the RST button.
- Note that holding the RST button for too long (e.g. 20+ seconds) will cause the PDU to enter static IP mode addressing. Ensure to let go of the RST button as soon as you see the AC current amps turn off.
- This resets all settings, including the admin credentials.
- Power to outlets will not be affected.
